-
-
=========================================================
-
- use the (up) and (down) arrow keys to move the pointer to the desired boot device.(使用（向上）和（下）箭头键将指针移动到所需的引导设备。)
- press [Enter] to attempt the boot or ESC to cancel.(* = password required)(按[Enter]尝试启动或按ESC取消启动。（*=需要密码）)
- boot mode is set to:uefi;secure boot:off;ptt is on;（引导模式设置为：uefi；安全引导：关闭；ptt打开；）
- uefi boot(uefi引导):
- windows boot manager(windows启动管理器)
- onboard nic(ipv4)(onboard nic(ipv4))
- onboard nic(ipv6)(onboard nic(ipv6))
- other options:(其他选项：)
- bios setup(bios设置)
- device configuration(设备配置)
- bios flash update(bios闪存更新)
- diagnostics(诊断程序)
- supportassist os recovery(支持辅助操作系统恢复)
- bios flash update-remote(bios闪存更新远程)
- change boot mode settings(更改引导模式设置)
- exit boot menu and continue(退出引导菜单并继续)
--------------------------------------------------------------------------------------------
-
-
-
-
-
-
-
-
-
-
-
-
- This list specifies the order that the BIOS searches edvices when trying to find an operating system to boot.
- To change the boot order select the device to be changed in the list on the right hane side. then click up/down arrows or use the keyboard PgUp/PgDn keys to change the boot order of the device.
- The boot devices can aiso be selected or de-selected from the list using the check boxes on the left hand side.
- 此列表指定BIOS在尝试查找要引导的操作系统时搜索设备的顺序。
- 要更改引导顺序，请在右侧的列表中选择要更改的设备。然后单击向上/向下箭头或使用键盘PgUp/PgDn键更改设备的引导顺序。
- 也可以使用左侧的复选框从列表中选择或取消选择引导设备。
-
- This option controis the on-board LAN controller.
- Disabled = The intemal LAN is off and not vislble to the oerating system.
- Enabled = The intemal LAN is enabled.
- Enabled w/PXE = The intemal LAN is enabled (with PXE boot).
- -- Enable UEFI Network Stack:If enabled UEFI Networking Protocois are installde/available.allowing pre-OS and early OS networking features to use any enabled NICs. This may be used without PXE tumed on.
- -- When Enabled w/PXE is selected the type of PXE boot(Legacy PXE or UEFI PXE)depends on the current boot mode and types of option roms in use. The UEFI Network Stack is required in order to have UEFI PXE functionality fully enabled.
- 此选项控制车载LAN控制器。
- Disabled=内部LAN已关闭，对oerating系统不可见。
- Enabled=内部LAN已启用。
- Enabled w/PXE=启用内部LAN（使用PXE引导）。
- --启用UEFI网络堆栈：如果启用UEFI网络协议已安装/可用。允许使用任何已启用的NIC的预操作系统和早期操作系统网络功能。这可以在没有打开PXE的情况下使用。
- --选择Enabled w/PXE时，PXE引导类型（传统PXE或UEFI PXE）取决于当前引导模式和使用的选项ROM的类型。需要UEFI网络堆栈才能完全启用UEFI PXE功能。
-
- 说明：通俗总结来讲，AHCI 模式与 RAID ON 模式，使用的驱动各不相同（且不通用），性能上差别并不大。
- This option configures the operating mode of the integrated SATA hard drive controller.
- Disabled = The SATA controllers are hidden.
- AHCI = SATA is configured for AHCI mode.
- RAID On = SATA is configured to support RAID mode (Intel Rapid Restore Technology).
- 此选项配置集成SATA硬盘驱动器控制器的操作模式。
- 禁用=SATA控制器被隐藏。
- AHCI=SATA配置为AHCI模式。
- RAID On=SATA配置为支持RAID模式（Intel快速恢复技术）。
-
- This fiele configures integrated USB controller.
- Enable USB Boot Support:When enabled the BIOS will allow booting to USB mass storage devices(i.e. HDD.Memory Sticks.Floppy Drive.etc.).
- When disabled.the BIOS will prevent booting to USB mass storage devices. This setting affects pre-boot functionality only. This setting does not affect access to hte USB edvices from within the operating system.
- Note:If the Fasboot option is set to"Minimal".the "Enable USB Boot Support"setting is ignored and the system will not boot from any Pre-boot USB devices.
- Enable Extemal USB Ports:When enabled USB devices attached to the platform's USB ports are visble and available for use from within the operating system.
- When disabled any connected USB devices are not visible from within the operating system.This setting also disables USB on the Type-C port.
- Note:a USB keyboard and/or mouse connected to the piatform"s USB ports will continue to function within BIOS Setup if this option is disabled.
- 此字段配置集成USB控制器。
- 启用USB引导支持：启用时BIOS将允许引导到USB大容量存储设备（即。硬盘存储器棍子。软的驱动器等.).
- 什么时候禁用BIOS将阻止引导到USB大容量存储设备。此设置仅影响预引导功能。此设置不影响从操作系统中访问USB设备。
- 注意：如果Fasboot选项设置为“Minimal”。“Enable USB Boot Support”设置被忽略，系统将不会从任何预引导的USB设备引导。
- 启用外部USB端口：启用时连接到平台USB端口的USB设备是可见的，并且可以从操作系统中使用。 禁用时，从操作中看不到任何连接的USB设备系统。这个设置还会禁用Type-C端口上的USB。
- 注意：USB如果禁用此选项，连接到piatform USB端口的键盘和/或鼠标将继续在BIOS设置中工作。
-
- Depioyed Mode - Changes to the Secure Boot operation mode modifies the behavior of Secure Boot to allow evaluation or enforcement of UEFI driver signatures Deployed Mode should be selected for normal operation of Secure Boot.
- Deployed Mode-Checks the integrity of UEFI drivers and bootloaders before allowing execution.Use this mode for full Secure Boot protections.
- Audit Mode - Performs a signature check but does not block execution of all UEFI drivers and bootloaders. Use thio mode when making modifications to Secure Boot Keys.
- 分离模式 对安全引导操作模式的更改会修改安全引导的行为，以允许评估或强制执行UEFI驱动程序签名部署模式应选择用于安全引导的正常操作。
- 部署模式检查UEFI驱动程序和引导加载程序的完整性，然后允许执行。使用此模式用于完全安全引导保护。
- 审核模式-执行签名检查，但不阻止所有UEFI驱动程序和引导加载程序的执行。在进行修改以保护引导密钥时使用thio模式。
--------------------------------------------------------------------------------------------
-
-
如不能显示效果，请按Ctrl+F5刷新本页